Composite Envisions Infusion Epoxy

Description

Composite Envisions Infusion Epoxy is the next generation of our house brand epoxy system that has been custom formulated for use in resin infusion and VARTM processes to provide rapid saturation of carbon fiber, fiberglass and Kevlar laminates. Processability parameters are enhanced due to the infusion epoxies low mixed viscosity and wet-out potential while also allowing for maximum open time. Improving on an already great formula this infusion epoxy has added benefits such as extensive testing and enhanced physical properties. One notable property is the increased Heat Deflection Temperatures noted in each of our hardener selections.

This enhanced resin can be used to fit your process with our selection of Slow, Medium, or Fast Hardeners. The adjustable nature of this epoxy allows for a blending of slow, medium and fast hardeners that can be used to create a speed that fits your process.

Slow Hardener will provide the maximum in possible working time of ~210 mins in ideal room temp conditions and features a heat deflection temp of 183°F.

Medium Hardener is considered to be the best of both worlds as a medium hardener, featuring a working time of ~120 mins and a heat deflection temp of 195°F.

Fast Hardener will provide ~25 mins of working time and a heat deflection temp of 181°F.

Key Features:

• High Thermal Properties with proper post cure
• Ultra Clear System
• Enhanced Degassing Properties
• Low Viscosity
• No hazmat fees on small kits
• Adjustable Speed – Can blend slow, medium and fast hardeners to create a speed that fits your process
• Extensive material testing with enhanced data sheets

This is very user friendly system which will provide the results needed to produce high end composite parts that not only look good, but have the structural mechanical properties to back it.
This system was formulated and small kits are packaged in a manner that now avoids the expensive HAZMAT fees the carriers charge.

The storage temperature of will greatly affect the ease of mixing, application and curing time. For best results, epoxy and hardeners should be stored at (60-80 °F or 16-27 °C) for at least 24 hours before use. Mix RESIN WITH HARDENER for 3 minutes using a Jiffy Mixer and a slow speed drill. Mix at slow speed (less than 500 rpm) to avoid air entrapment. When adding part B to part A, be sure to scrape the sides of the hardener (part B) container in order to remove all of the hardener. This is essential to maintain proper mix ratio. DO NOT mix more material than can be used within the stated working time. REMEMBER – you will have less working time at higher temperatures

This epoxy product is made proudly here in the USA.

Note: This system is not designed for use in open mold applications.