null

Choosing The Best Flow Line Set-up For Your Vacuum Infusion Project

Jun 23rd 2021

When setting up for vacuum infusion, there are a few different ways you can set up your flow lines. This can depend on the individual project as well as the size of it. Here we take a look at what is the best course of action for setting up your flow lines.

Lateral feed lines are best used when a part has a square like dimension or when infusing square panels. Running an inlet and outlet spiral tube of the same length parallel on each side will provide equal resin flow throughout the area of the part. This way there will not be any resin rich areas in the part. This simple method offers the benefit of knowing when to turn the resin feed off to allow for adequate wetting and a more optimal resin / fiber ratio. Resin will quickly be dispersed evenly one side of the mold and drawn to the other side. This method is used best when dimensions are nearly even on end to end, like square shaped parts. Lateral feedlines provide a baseline of infusing simple parts and adjustments should be made accordingly for variations in the part’s ranging surfaces. The disadvantage to this method is that resin may need to travel longer distances, the farther the resin goes, the slower it will travel through the laminate. As parts grow more complex in radial areas and as part contours develop, changes can be made to provide resin from the perimeter of the mold to adequately wet out plys.

Center feed lines could best be used when the part has a circular or hull shape. Spiral wrap should be placed along the perimeter to draw resin evenly throughout the surface of the part. This will make for an even draw resin throughout the part. This method may take some experimentation to provide the most effective center line in which resin will reach the spiral wrap throughout the perimeter at roughly the same time. A center feedline is also a good option when there is a gap or hole in the part to provide an easy means to place the vacuum port in which spiral wrap can then be used along the centerline of the part as a means of dispersing resin. This method can be used for making parts such as kayaks, small hulls, or similar shaped objects.

Multiple feedlines are used generally for larger and more complex parts in excess of 50 sq ft, such as a +20’ boat hull, a yacht, airplane hulls, etc. Composite processes are best when processes are kept as simple as possible. However, a single feedline is not always enough to provide and even amount of resin to enter the part and provide a total wet out of fibers. It is generally a good idea for a more experienced operation to perform this type of infusion. If done improperly it can lead to wasted resources and possibly a scrap part from not wetting all the laminate. Multiple feedlines are best used across complicated or changing surfaces in the tool. In this case the multiple feedlines cater to specific sections of the mold in which may be hard to reach with a single line. Multiple feed lines often take a few times to get correct and can change from layup to layup to produce the most consistent finish. As another advantage, multiple feedlines also give the operator for control over resin flow as each line can be turned on and off as resins travel throughout the part. This way an even amount of resin throughout the part may be achieved.

Hopefully this brief post helped with any questions you had about the best way to set up your flow lines for vacuum infusion. As always, feel free to contact us with any questions you may have.