3:1 Epoxy Hardener - medium cure

Ground Only

Our 3:1 Hardener is considered to be a medium cure hardener, Our 2:1 epoxy will cure slower and our 4:1 hardener epoxies will cure much faster. However this 3:1 hardener will provide you with the best of both worlds.

This Hardener must be used with either our Thin Epoxy or Thick Epoxy Resin.

Mixing 3 parts epoxy to 1 part hardener will give you the appropriate final mixture.

The appropriate amount of Resin needed for each size Hardener;
12oz Hardener --- 1 Quart Resin
24oz Hardener --- 1/2 Gallon Resin
1 Quart Hardener --- 3 Quarts Resin
1/2 Gallon Hardener --- 1 1/2 Gallons Resin
1 Gallon Hardener --- 3 Gallons Resin

The 3:1 hardener has a pot life of 20-25 minutes at 80° F, set time of 3-4 hours and a drying time of 8-10 hours.

Notice: This product may Blush.

The item has a shelf life of approximately one year. To ensure quality results and proper curing, please make sure to use the resin shortly after purchase.

*** Cold Weather Warning ***

If your epoxy arrives cold during shipment is must be allowed to acclimate to at least 75° F before using. Mixing this product below 75°F will increase the potential for under-mixed epoxy which will create wet or sticky areas on your surface. Cold temperatures will also trap more very tiny air bubbles during the mixing which cannot always be removed with the torch/heat gun. In addition applying the mixed epoxy in temps below 70° F will drastically extend cure times. To warm the epoxy quickly we recommend using either a heat lamp, an electric heater or placing the closed bottles of epoxy in a tub of warm water for 30 minutes. Getting the epoxy too hot will result in a faster reaction time, so pay careful attention to what you're doing.

*** Cold Weather Warning ***

MSDS3:1 Hardener SDS

PDF Epoxy Mixing Guide