FREE Shipping on all orders over $50.00!


702-061 Duratec Black EZ Sanding Primer 1-Gal

Model: 1331


  • Description
  • Details
  • Reviews

An exceptionally easy to-sand primer, that can be polished to a smooth, porosity-free surface. 

Catalyst (MEKP) is NOT included with this product but can be purchase separately HERE

Uses: for surfacing patterns for composite molds, and where an easy sanding, high build primer is required..  Apply over tooling board, MDF, brick, concrete, plaster and clay. 

Features:

  • Builds rapidly and provides a surface that sands quickly.
  • Use less sandpaper
  • Reduce sanding labor
  • Easy to spray from HVLP guns. Low porosity, fine smooth surface.
  • Start sanding with a fine grit, reduce dust and film loss.
  • Build up to 30 mils.
  • Adhesion to most epoxies.
  • Heat distortion temperature of 83° C, 180° F
  • Not recommended for use on CNC patterns over a low (less than 120° F) HDT tooling putty.

Use Instructions:

Assure that the work area is at least 60°F, and that the Duratec and the part that will be sprayed are at least 60° F.  Compressed air must be free of water. Mix the Duratec EZ Sanding Primer with a paint shaker or drill-mounted mixer.  Use a stir stick to scrape the bottom of the container before mixing. 

Please view the application guide and technical data sheet below for information on cure times, application methods and equipment needed to properly use this material. 

EZ-sanding primer available in the following models 707-061 Lt. Grey, 702-061 Black, 714-061 White

Technical Data Sheet and Application Guide Duratec 702-061 TDS.PDF
MSDS Duratec 702-061 MSDS.PDF
Duratec Product Line Duratec Product Line Brochure.PDF
Duratec Product Selector Guide Duratec Product Selector Guide.PDF
  • Model: 1331
  • Shipping Weight: 13lbs
  • 2 Units in Stock

Be the first to write a review.  Write a Review.